15398 Autoloader ALE: Important! Visually inspect the drum. If drum is EMPTY, click MEDIA CLEAR. Otherwise, click RESUME. Trendsetter_400/800_Proofing Open the front or top door of the machine and check inside the machine. If the drum is empty, close the door and click "MEDIA CLEAR". If the drum is NOT empty, close the door and click "RESUME". Make sure the customer visually inspect the drum. In addition, remove any flyoff media in the machine. While clearing a previous error, the operator clicked "MEDIA CLEAR" without manually remove the carrier or plate. This caused the firmware to think that the drum is empty yet there is actually something on the drum. Mis-use of the "proof mode" command. ../commands/proof_mode.xmlCommand: proof mode ../nvs/proof_cal_dvct.xmlNVS: proof dvct ../nvs/plate_loc_state_status.xmlNVS: plate_loc status ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:08 2008 PST